Filter
Top Products
‘b replace hood lamp, first disconnectpower at
front until it stops. Remove.Replacewith same type
mainfuseor circuitbreakerpanel or pull plug. Re-
and wattage lamp. Hold lamp near each end and”in-
move 2 screws from each side of lower panel and 3
sert prongs in sockets,Gentlyroll top of lamptoward
screws from front edge. Lower panel until it rests on
rear of range until it stops. Raise lower panel and
range below. Place fingers on top near each end of
replacescrews.
lamp. Press down and roll top of lamp gently toward
?r-
0
TotwplaceYouroven Iammfirst disconnectpowerat
Clean off the grease and
dust on hood surfaces
often,Use a warm detergent solution, About 1 table-
spoon of ammonia may be added to the water, Take
care not to touch the filters and enameled surfaces
with this. Ammonia
wiilMd to darkenmetal,
main-fuseorcircuitbreakeror pullplug.Removethe
top grill by taking off 2 screwswhich hold it in place.
Next, remove the singie screw on top left that
secures lamp housing, (On models so equipped,)
Open oven door for easier removalof the iamp hous-
ing assembly.Then grasp tab and pull out and up to
clear door hinge and front lip of oven. To remove
bulb, push it inward gentiy and turn to left, then pull
outward from socket. F@place with GE Lamp
# 2W”M3C.
Da notattemptto operatetheoventmlmsthegrillis
[nplace,
&
19