Filter
Top Products
REPLACING THE REFRIGERATOR DOORS
(cont.)
Insert the top hinge pin into the hinge hole on top of the
refrigerator door. Make sure the door is aligned with the
cabinet and opposite door. Attach the hinge to the top
of the cabinet. Do not tighten bolts completely.
On left-hand doors, pass the wires and water line
through the top hinge pin. Then connect the water line
and door electrical connector.
Attach the ground wire with a Phillips-head screwdriver
at the right and left hinge.
Make sure the gasket on the door is flush against
the cabinet and is not folded. Make sure the door is
straight and the gap between the doors is even across
the front. While holding the aligned door in place,
tighten the top hinge bolts.
Reconnect all connectors at the left and right sides of
the top cap. Reattach the three Phillips-head screws
on top.
Installation Instructions
E
F
G
29
D
H
6
REMOVE THE FREEZER DOOR
Pull the freezer door open to full extension.
Remove the freezer bin by pulling both brackets upward
at the same time. (See page 19.)
Take out the lower basket by lifting the basket up from
the rail system. (See page 19.)
Remove the two 10 mm hex-head bolts from the right
and left side.
A
B
C
D
7
Ground
Wire