GE XL44 Range User Manual


 
38
INSTALLATION INSTRUCTIONS
(continued)
(continued next page)
The flames for the top (broil) burner should be
steady with approximately 1blue cones and should
not extend out over the edges of the burner baffle.
To determine if the bottom burner flames are
burning properly, remove the oven bottom.
Flames should have approximately 1 blue cones
and, if range is supplied with natural gas, should
burn with no yellow tipping. (With most LP gas,
small yellow tips at the end of outer cones are
normal.) Flames should not lift off burner ports.
If lifting is observed, gradually reduce air shutter
opening until flames are stabilized.
To remove the oven bottom:
1. Remove the knurled screws holding down
rear of the oven bottom.
2. Grasp the oven bottom at finger slots on
each side.
3. Lift the rear of the oven bottom enough to
clear the lip of the range frame, then pull out.
ADJUST BROIL AND OVEN BURNER AIR
ADJUSTMENT SHUTTERS ON MODELS WITH A
STORAGE DRAWER, IF NECESSARY (See Step 9
if your range is equipped with a broiler drawer.)
Air adjustment shutters for the top and bottom
burners regulate the flow of air to the flames.
The air adjustment shutter for the top
(broil) burner is in the center of the rear
wall of the oven.
The shutter for the bottom (oven) burner is
near the back wall behind the storage drawer
or the kick panel (depending on the model).
Remove the drawer or panel. See the Care and
Cleaning section in this guide.
To adjust the flow of air to either burner, loosen
the Phillips head screw and rotate the shutter
toward open or closed position as needed.
8
Air adjustment
shutter
Loosen
Loosen
Air adjustment
shutter
Oven
bottom