GE Monogram ZIS42N Refrigerator User Manual


 
ZKH1 Trim Kit (For 1/4" Panels)
Support for Custom Handles
Handle Bracket
Handle Bracket
Custom Handle
Dispenser Trim
Dispenser Trim
Option 2 Installation
Step 4
Install
custom handle
Step 5
Mount
assembled
dispenser trim
Drill clearance holes through the handle bracket and
the dispenser trim.
Install screw(s) long enough to pass through the
handle bracket, dispenser trim and into the
custom handle.
Note:
The custom handle must
be installed against the handle
bracket. The custom handle
cannot exceed 11-3/4" length.
Important:
The handle
bracket must be secured to the
steel door. If it is not secured
properly, the dispenser trim will
pull away from the door.
Mount assembled dispenser trim with handle onto
the door.
Drive 2 screws through the top and bottom of the
handle bracket into the steel door.
Re-install 3 screws at top and bottom of
dispenser trim.
Slide decorator panels into the trim, top and bottom.
Slide freezer door extrusion in between panels and
steel door. Secure with screws.
To install fresh food handle follow the same procedure
as shown in Option 1.
Step 6
Install
custom handle
extrusion
25
Freezer
Handle Side
Extrusion
ZKH1
INSTALLATION
Secure
Handle
Bracket
With
Screws
Secure
Assembled
Dispenser
Trim
With
Screws