Filter
Top Products
40
ZKHSS1 for 1/4" Panels
Tubular Stainless Steel Handles
Step 3:
Install
Standoffs
onto Handles
• Place a handle standoff on each attachment post
along the handle. Position the set screw hole on each
standoff to point to the floor.
• Install set screws into the bottom of each standoff,
using the Allen wrench provided. The standoff should
be tight against the handle.
Step 4:
Install
Handles
and
Panels
Screw
Allen Wrench
If you are installing these handles onto Stainless Steel
panels:
Use extreme caution if you are drilling through
stainless steel panels. Stainless panels must be
handled gently. Do not kneel on stainless steel panels.
It will leave a permanent dent. Do not remove protec-
tive plastic covering until final installation.
• Place supplied filler panel (corrugated) on floor to use
as a pad.
• On the back side of the panel–at the handle side,
measure and mark 1/4" below the top edge of the
panel.
For models with full width dispenser trim and 2-piece
freezer panels:
–Measure and mark 1/4" below the top edge of the
upper panel.
–Measure and mark 1/4" above bottom edge of lower
panel.
• Slip panels into the new extrusion, flush against inner
edge, on the handle side.
• Align extrusion to pencil mark(s) as shown in Step 2.
Mark each screw hole location with pencil.
• Tape extrusions to panels to prevent movement.
• Place panel on plywood section, appearance side
down. Be sure plywood is clean without nicks and
burrs. Center punch at each screw hole location.
• Drill 1/8" pilot hole. Use 9/32" bit to enlarge clearance
hole.
• Measure and cut a 2" wide strip, top to bottom off the
corrugated panels. This will allow room for spacer
rings between the stainless panel and extrusion.
• Press foam pads against steel doors to temporarily
reduce thickness.
• Slide panels into the door trim. Leave about 4" of the
panel exposed to allow room to install the handle
extrusion.
• Place extrusion onto back side of panel, install
mounting screws through the extrusion and the
custom panel.
• Screw handle to panel, starting at the top. Moving
down the handle, drive each screw partially into the
standoff, alternating back to the top until the handle is
tight against the panel.
• Slide the assembly into the door frame until the
extrusion fits firmly against the steel door.
• Reinstall original screws into the door extrusion.
Step 2A:
FOR
STAINLESS
STEEL
PANELS
Door
Handle
Screw
Handle
Decorator
Door Panel
FOR CUSTOM
WOOD
PANELS
See Step 4A
for Stainless
Steel panels
ZKHSS1
INSTALLATION