Filter
Top Products
42
ZKHTSS1 for 3/4" Panels
Tubulor Stainless Steel Handles
This kit provides for the installation of Stainless Steel
custom handles on 3/4" thick decorator door panels.
The door extrusions allow these custom handles to be
secured to the door structure, rather than to the
custom panels. This kit contains all the necessary parts
for dispenser and non-dispenser models.
Before
You
Begin
• 3/4" custom panels must be routed to accommodate
these handle extrusions. Rout the panels as
illustrated, 1/4" deep, and 1-13/16" wide, top to bottom
on the handle side.
• Follow the instructions in the ZKT trim kit to install
support brackets to the bottom of the fresh food and
freezer panels. For models with full width dispenser
trim, install the support bracket to the bottom of the
lower panel only. Do not install a bracket to the top
of the lower panel or the bottom of the upper panel
as shown in the ZKT trim kit instructions. These
brackets are not required for this kit.
This kit must be used in combination with ZKT42, ZKT42
or ZKT48 trim kit.
The ZKT trim kits provide the framework to support 3/4"
thick panels. This kit provides handle side extrusions
and handles to match that ZKT framework.
Note:
It is best that 2 people install this kit.
Tools and materials required:
• #2 Phillips screwdriver
• Drill and 1/8", 9/32" bits
• Custom door panels
• Safety glasses
• Center punch
• Masking tape
• Hammer
• Pencil
• 1/2" thick 12" x 12" min. piece of
plywood to protect floor when
drilling
• For stainless steel panels wear
gloves to
protect against sharp edges.
Parts List:
A. Fresh food door extrusion
B. Freezer door extrusion
C. 2 Stainless tubular handles
D. 8 Handle standoffs
E. 10 Screws for mounting handle
standoffs
(8 required, 2 extra)
F. 10 Set screws (8 required,
2 extra)
G. 3/32" Allen wrench for set
screws
A
B
C
D
F
G
E
1-13/16"
1-13/16"
Back Side
Handle Side
Handle Side
Freezer Panel Fresh Food Panel
1/4" Max.
Back Side
Hinge
Side
Fresh Food Panel
Freezer Panel
Support Bracket
Support Bracket
Bottom Edge
Bottom Edge
Back Side Door Panel
Install bottom support brackets only.
ZKHTSS1
INSTALLATION