Filter
Top Products
12
Custom Panel Dimensions
42" Built-In Refrigerator
ZISW42D (white dispenser)
ZISB42D (black dispenser)
• The ZKT42 trim kit provides for the installation of 3/4"
custom door and grille panels, using the standard full-
length handle. Cut panels to size and install.
• For standard dispenser trim: Cut panels to size, rout the
bottom of the upper freezer panel and the top of the
lower freezer panel to allow placement of support
brackets and install (see detail A).
• For custom dispenser trim ZWCD1 kit must be used: Cut
panels to size, refer to detail B for dispenser cutout
routing instructions and install. When a raised panel
design is used, a custom middle rail is required. A
14-1/2" wide middle rail must be used because the
custom collar trim must be located within the raised
portion of the panel. This area must be 3/4" thick. See
detail C for raised panel design requirements.
Custom Door Panel Dimensions
Using Trim Kit ZKT42
3/4" thick panel with standard handle
and/or ZWCD1 custom collar trim
Installation Height Dimension A
83" 8-1/4"
83-1/2" 8-3/4"
84" 9-1/4"
84-1/2" 9-3/4"
Important:
Maintain 1-1/2" min. gap between
top of doors and bottom of grille panel.
Grille Panel height can vary to fill installation
height.
Detail A
Upper
Freezer
Panel
Lower
Freezer
Panel
Panel
Face
1"
1"
3/32"
CUSTOM PANEL
DIMENSIONS
9 7/16"
12 5/16"
7/8"
Wide
Rout
The Cutout is 9 7/16" wide
by 12 5/16" high. 3/4" panels
must be routed on all four
sides of the cutout. Rout
the back side of the panel
1/4" deep. 7/8" wide
(shaded area).
Detail B Custom
Dispenser Cutout
16 11/16"
37"
2 5/16"
67 15/16"
15 1/16"
25 1/16"
17 11/16"
Fresh Food
Panel
Freezer Panel
Standard
Dispenser
Freezer Panel
Custom
Dispenser
15-1/16"
Custom Grille Panel
41 1/2"
A
Over 1/4" Thick (3/4" max) Panel
Hole is
Cut
After Door
Fabrication
14 1/2"
Wide
Middle
Rail
Detail C
Raised Panel Design
Handle
Side
A
A
Section AA
*Custom Stiles and
Middle Rail Required
*3" Stiles
Left Side
*2-3/16" Stiles
Right Side
Important: Maximum weight for fresh food panels is
50 pounds and 30 pounds for freezer door panels.