GE Monogram ZISW42D Refrigerator User Manual


 
Again, with both doors closed, check the location of
the centerlines to be sure they are parallel to the edge
of the door, and level with opposite door.
Drill 1/16" pilot hole through the panel until it starts into
the aluminum extrusion. This will mark the matching
location for drilling the clearance hole when assem-
bling the handle, panel and extrusion.
Note:
Handle must be located
3/4" to 1-1/2" from edge of
extrusion.
ZKH1 Trim Kit (For 1/4" Panels)
Support for Custom Handles
Step 2
Locate position
of handles
Option 1 Installation
Slide custom panels into fresh food and freezer door
frames.
Temporarily secure the new door extrusions to the
doors. Use at least 2 screws on each door.
The handles must be located 3/4" to 1-1/2" from the edge
of the extrusion.
Determine the desired location of the custom handles
and carefully mark centerlines of the screw holes.
22
3/4" Min.
1-1/2" Max.
Door Extrusion
ZKH1
INSTALLATION