Filter
Top Products
31
ZKT42 Trim Kit
3/4" Custom Panels
Dimension B
ZKT42–6-3/4"
Dimension A
ZKT42–4-3/8"
Dimension C
ZKT42–4-3/8"
• Position and mark the location for the support
brackets on the back side of the panels. Align all
brackets flush with the end of the panels, with tabs
protruding over the edge.
• On the bottom of the upper panel, measure
dimension A from the hinge side.
• On the bottom of the lower panel, measure
dimension B from the hinge side.
• On the top of the lower panel, measure dimension C
from the hinge side.
• Secure all brackets with #4 screws provided.
• Attach the new 3/4" trim pieces at the top and hinge
side using original screws.
Step 3
Install panel
support brackets
Step 2
Install
3/4" trim
OPTION 2
For dispenser
model using
full-width
trim
Step 1
Remove
handles & trim
• Open freezer door to 90°.
• Remove the Phillips head screws from the full-length
handles.
• Open door fully to stop.
• Remove screws from the aluminum trim, top, bottom
and hinge side.
• Remove the trim above and below the dispenser.
• Retain screws and full-length handles. Discard
original trim.
Back Side
of Freezer
Panels
Hinge
Side
Upper
Panel
Lower
Panel
A
C
B
ZKT42
INSTALLATION