GE Monogram ZISW42D Refrigerator User Manual


 
4
DESIGN
INFORMATION
Design Information
42" Built-In Refrigerators
Installation
At End-of-Run
Frameless
Cabinets
Note: 1/2" thick side panels shown. Side panels can
be any thickness. Add side panel thickness to outside
trim width (42") to calculate the rough-in dimension.
The leading (front) edge must be finished to match
surrounding cabinetry.
Side panels, 1/2" minimum thickness are
required when using frameless cabinets.
The side panel acts as a spacer between the
cabinet and the case trim and prevents
interference with cabinet door swing. The
leading (front) edge must be finished to
match surrounding cabinetry.
1/2" To 3/4" Side Panels. Leading
Edge Flush With Cabinet
1/2" To 3/4" Side Panels. Leading
Edge Flush With Cabinet
Refrigerator
Cabinet
Refrigerator door
Side panels are required whenever the sides of the refrigera-
tor will be exposed.
1/2" to 3/4" side panels are normally set into place and
fastened to adjacent cabinetry or to the back wall before
rolling the refrigerator into the opening.
Installation
Between
Base &
Wall Cabinets
Note: 1/4" thick side panels can be
inserted into the case trim, making the
rough-in the same as the outside trim
width, 42".
1/4" Side Panels. Insert end of
side panel into trim
Installation Examples
Therefore, the rough-in dimensions must allow for side panel
thickness. In both a flush and semi-flush installation, the
finished dimension, (the width of the opening after side panels
are installed), must accommodate the full width of the
refrigerator.
See page 14 for side panel sizes.
Flush and Semi-Flush
Installations
Cabinet
Refrigerator door
Refrigerator
Cabinet
Flush and Semi-Flush
Installations
Refrigerator
Cabinet
Refrigerator door
Cabinet
Accessory
Panel Kits
Field installed door and grille panels are required. The factory
installed trim will accept accessory panel kits. White or black
Lexan
®
and stainless steel kits are available. Panels are cut to
size and ready to install. These panel kits must be ordered
separately.
Model Black White Stainless
ZIS42N ZWBP42 ZWWP42 ZWSP42
ZISW42D ZWWP42D ZWSP42D
ZISB42D ZWBP42D ZWSP42D
A wide range of custom appearance options can be created
with optional custom trim kits. See the opposite page for
examples and trim kit descriptions.
1/4" Thick
Side Panels
41-1/2"
Finished Dim.
42"
Roughed-In Dim.
43"
1/2" Thick
Side Panels
42"
Finished Dim.
Rough-In Dim.