Filter
Top Products
47
ZWCD1 Trim Kit
Custom Dispenser Collar
Note:
1/4" door panels do not
require routing.
• Secure top and bottom brackets to the dispenser,
using the screws previously removed.
• Install the custom panels according to the appropriate
installation instructions.
• Select the black or white collar trim according to
appearance desired.
• Match the indentations on the collar trim to the tabs
on the lower bracket. Push the collar flush against
the door.
• Drive 2 screws (provided) upwards through the collar
and into the brackets.
The use of this custom collar trim requires that the hole
for dispenser be located and cut
very accurately
. 3/4"
door panels must be routed on all 4 sides of the
dispenser cutout.
Rout the back side of the panel 1/4" deep and 7/8" wide,
flush with the edge of the cutout.
Select the door panel size for your application.
• If using the standard 1⁄4" trim, follow the installation
instructions packed with the product.
• When using another optional trim kit, use the
instructions provided with that kit to install the panel
trim and/or custom handles.
• Remove the aluminum trim above and below the
dispenser. Discard trim.
• Remove and discard the standard full-width
dispenser trim.
• Remove 2 screws above and below the dispenser
recess. Retain screws.
Cut dispenser
hole and rout
door panel
Install
collar
brackets
and trim
ZWCD1
INSTALLATION
9 7/16"
12 5/16"
7/8"
Wide
Rout
The Cutout is 9 7/16" wide
by 12 5/16" high. 3/4" panels
must be routed on all four
sides of the cutout. Rout
the back side of the panel
1/4" deep. 7/8" wide.