Filter
Top Products
G9922
-17-
Assembly
Assembly for the Model G9922 consists of put-
ting together the machine stand, attaching the
machine to the stand, then inserting the sanding
spindle.
To assemble the machine:
1. Lay out two legs, one upper brace and one
lower brace, then connect them using four
M8-1.25 x 16 carriage bolts, four 10mm flat
washers, four 8mm lock washers, and four
M8-1.25 hex nuts, as shown in Figure 9. Do
not yet fully tighten the nuts.
Figure 11. Completing stand.
Figure 9. Leg assembly.
Upper Brace
Lower Brace
Legs
2. Repeat Step 1 to create a second assembly.
3. Connect the two assemblies together with
one lower and one upper brace, using four
M8-1.25 x 16 carriage bolts, four 10mm flat
washers, four 8mm lock washers, and four
M8-1.25 hex nuts, as shown in Figure 10. Do
not yet fully tighten the nuts.
Figure 10. Connecting leg assemblies.
Lower Brace
Upper Brace
4. Carefully turn the assembly over and attach
the remaining upper and lower braces. Again,
use four M8-1.25 x 16 carriage bolts, four
10mm flat washers, four 8mm lock wash-
ers, and four M8-1.25 hex nuts, as shown in
Figure 11. Do not yet fully tighten the nuts.
Lower Brace
Upper Brace