Filter
Top Products
-24-
G9922
Sanding Sleeve
The sanding sleeves on the Model G9922 can be
replaced when they become worn or damaged.
To replace sanding sleeves:
1. DISCONNECT SANDER FROM POWER!
2. Use a 19mm wrench on the sanding drum
base nut to keep the spindle from turning
(Figure 29).
3. Remove the plastic cap from the sanding
drum. It has left-hand threads and unscrews
clockwise (Figure 30).
4. Loosen the hex nut until the sanding sleeve
can slide off the drum. The hex nut has left-
hand threads and unscrews clockwise.
5. Slide the new sleeve over the drum, then
tighten the hex nut and replace the plastic
cap.
Figure 29. Securing spindle.
Sanding Drum Base Nut
Sanding Drum
Figure 30. Loosening nut.
Plastic Cap
Hex Nut
6. Hold the workpiece flat on the table and
against the miter gauge, and begin sliding
the gauge back and forth in the slot on the
table. At the same time, gradually move the
workpiece into the sanding drum (Figure
28).
Figure 28. Workpiece placement.
7. Continue sliding the miter gauge back and
forth while applying slight pressure against
the sanding drum. Once sanding is complete,
slide the miter gauge away from the drum,
and turn the sander OFF.