Filter
Top Products
-22-
G9922
Table Tilt
The table on the Model G9922 can be tilted up to
45° for sanding beveled edges.
To tilt the table:
1. DISCONNECT SANDER FROM POWER!
2. Loosen the two lock knobs, located on each
side of the table tilt assembly (Figure 22).
Figure 22. Table lock knobs.
3. Adjust the table to the desired angle using
the angle gauge as a guide. Once the angle
is set, tighten both lock knobs (Figure 23).
Figure 23. Adjusting angle.
Table Tilt Lock Knobs
Angle Gauge
Note: The angle gauge is only for approximate
angle measurements. For precise angle set-
ting, use an adjustable angle finder between
the table and sanding drum.
0º Table Stop
The Model G9922 has a 0° table stop that lets
you easily set the table tilt back to 0º for sanding
square edges.
To set the 0° stop:
1. DISCONNECT SANDER FROM POWER!
2. Loosen the jam nut and turn the stop bolt
several turns clockwise (Figure 24).
4. Turn the stop bolt until it just touches the bot-
tom of the table. Then, without turning the
stop bolt, tighten the jam nut against the stop
bracket.
3. Use a square to set the table perpendicular to
the sanding drum, then securely tighten both
lock knobs (Figure 25).
Figure 24. 0° stop.
Figure 25. Squaring table to drum.
Jam Nut
Stop Bolt
Stop Bracket
Square
Lock Knob (x2)