Filter
Top Products
G9922
-23-
Contour Sanding
To sand a workpiece:
1. DISCONNECT SANDER FROM POWER!
2. Adjust the table tilt, if desired.
3. Ensure that the spindle hex nut is secured
tightly and that the work area is free of
obstructions and obstacles.
4. Connect the sander to power, turn ON the
spindle sander and allow it to reach full
speed.
5. Using both hands, guide the workpiece
against the sanding sleeve, as shown in
Figure 26 always working against the direc-
tion of rotation. DO NOT force the workpiece
against the sanding drum.
Miter Gauge
The Model G9922 includes a miter gauge that
can be used for sanding miter-cut edges at angles
from -60° to 60º.
To use the miter gauge:
1. DISCONNECT SANDER FROM POWER!
2. Place the miter gauge into the slot in the
table.
3. Loosen the miter gauge lock knob. Twist the
miter gauge until the desired angle is indicat-
ed, then tighten the lock knob (Figure 26).
4. Place the workpiece on the table against
the miter gauge. Make sure there is clear-
ance between the sanding drum and the
workpiece.
5. Connect the sander to power and turn the
sander ON.
Figure 26. Sanding.
Figure 27. Miter gauge.
Miter Gauge
Miter Gauge Lock Knob
Indicator
This sander creates substantial amount of
wood dust while operating. Failure to wear
a respirator rated for wood dust and use an
adequate dust collection system when oper-
ating this machine can result in short and
long-term respiratory illness.