Filter
Top Products
6. Using a l/Z” wrench, tighten the nut (already threaded
on the cable) against the weight securing the cable into
the weight.
ull
.\
\ \., “‘@l$
cable over pulley and down behind the weight.
,” $,#
&i,!
\.,“,,
,;
8. Thread the other end of the cable through a 5/16” nut on
-
The safety cable should now have some slack in it, with
‘,
the underside of the bracket.
9. Tighten the cable up by screwing the cable through the
nut, until the weight becomes level.
the weight level.
10. Tighten the nut against the bracket, securing the cable.
11. Replace the back shroud. Repair is now complete.