Filter
Top Products
Each electric fryer uses two heating elements.
Heating elements are available for 208 or 220/240,380
and 415 voltage. Check the data plate on the right side
panel of unit to determine the correct voltage.
If the shortening’s temperature recovery is very slow, or at
a slower rate than required, this may indicate defective heating
element(s). A multimeter will quickly indicate if the elements
are shorted or open.
1. Remove electrical power supplied to the fryer.
Remove electrical power supplied to the fryer by
unplugging the unit, or turning off the wall circuit
breaker or electrical shock could result.
2. Remove the Control Panel.
The following checks are performed with the wall
circuit breaker closed and the Power/Pump switch in
“Power” position. Extreme caution should be taken.
Make connections before applying power, take reading,
and remove power by unplugging the power cord, or
by turning off the wall circuit breaker, before remov-
ing meter leads, or electrical shock could result.
3. Perform an amp check on one heating element at a time
with the wires connected to the contactors. The two
heaters actually have three small heating elements on the
inside of the outer plate. It is important to check between
the correct wires to obtain an accurate amp reading. The
wires are labelled for your convenience.
ower
8500 w
203 v
47.3
L3 - L2
8500 w
208 v
47.9
L2 - Ll
8500 w
208 V
48.0
Ll - L2
8500 w
240 V
39.4
L3 - L2
8500 w
240 V
40.1
L2 - Ll
8500 w
240 V
39.9