Filter
Top Products
Updating the 10GbE pass-thru firmware 17
Port 13 is ENABLED
Port 14 is ENABLED
Port 15 is ENABLED
Port 16 is ENABLED
Port 1 Installed CU SFP
Port 1 Approved CU SFP
NOTE: If the module console displays C characters instead of . characters, return to step 14 to
restart the Xmodem transfer.
17. Press Ctrl + Shift + _. The following message appears:
Command: D)isconnect, C)hange settings, send B)reak, E)xit command mode
X)modem send >
18. Enter d.
19. To update the firmware on any other pass-thru modules installed in this enclosure, begin at step 4.
Updating the firmware image using a USB key and
the Onboard Administrator CLI
NOTE: The firmware update uses the Onboard Administrator Xmodem support with a firmware
file hosted on an HTTP, FTP, or TFTP server. The firmware transfer can take up to seven minutes
to complete.
If no HTTP, FTP, or TFTP server is available, you can download the pass-thru module firmware file to a
USB key which can then be inserted into the active Onboard Administrator USB port.
To update the image:
1. Copy the pass-thru module firmware file to the FAT32 formatted USB key in the \ directory.
2. Create a text file named text.cfg containing the following line:
hello
3. Copy the text.cfg file to the USB key in the \ directory.
4. Insert the USB key into the active Onboard Administrator USB port.
5. Log in to the active Onboard Administrator CLI.
6. At the Onboard Administrator prompt, enter show usbkey. The following message appears:
Configuration Script Files
---------------------------------------
usb://d1/test.cfg
7. At the Onboard Administrator prompt, enter show oa network. The following message appears:
Onboard Administrator #1 Network Information:
Name: marketing3
DHCP: Disabled
IP Address: 16.83.88.66
Netmask: 255.255.252.0
Gateway Address: 16.83.88.1
Primary DNS: 16.110.135.51