Filter
Top Products
– 5 –
INSTALLATION
UNPACKING
Immediately after unpacking the dishwasher, check for possible shipping damage. If this machine is
found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.
Prior to installation, test the electrical service to make sure it agrees with the specifications on the
machine data plate; this includes the optional electric booster, if equipped. The dishwasher data plate
is located at the bottom of the front panel.
INSTALLATION CODES
Installation must be in accordance with state and local codes, or in the absence of local codes, with
the National Fuel Gas Code, ANSI Z223.1 (latest edition) if applicable, and the National Electrical Code
ANSI/NFPA 70 (latest edition). In Canada, the installation standards are: CAN/CGA B149.1,
CAN/CGA B149.2, and CSA C22.2 No.1 (latest editions).
LOCATION
Before finalizing the location, make sure that consideration has been given for the electrical conduit,
water supply, drain connection, gas supply and venting (if applicable), tabling (if needed), chemical
feeder replenishment (if applicable) and adequate clearance for opening the door.
The dishwasher must be level before any connections are made. Turn the threaded feet (Fig. 2) as
required to level the machine and adjust to the desired height.
The edge of dish table that overhangs the AM15 wash tank should be turned down and fitted over the
top of the dishwasher tank (Fig. 3). Apply an NSF approved sealant between the overhang of the dish
table and the inner wall of the wash tank to prevent leakage (Fig. 3). Fasten the dish tables to the inner
wall of the wash tank with non-rusting truss head screws or rivets (Fig. 3).
For straight-through installations, clearance at the front and 15 inches out from the dishwasher at the
right side by 27 inches above the finished floor must be provided for servicing.
Fig. 2
Fig. 3
MACHINE LEG
ADJUSTABLE FOOT
WASH TANK
DISH TABLE
DISH TABLE
STRAIGHT-THROUGH OPERATION SHOWN
DISH TABLE
INNER WALL OF
WASH TANK
SEALANT
MACHINE SCREW
OR RIVET
NUT