Filter
Top Products
– 9 –
CHANGING SPEEDS
The GEAR SHIFT LEVER is used to change speeds. Always stop the mixer before changing speeds. To
change speeds, push the STOP button, move the gear shift lever to the desired speed, and restart the
mixer by pushing the START button.
Mixer Speeds
Speed 1 (Low) — This speed is for heavy mixtures such as bread dough, heavy batters, and potatoes.
Speed 2 (Medium) — This speed is for light dough which must rise quickly, cake batters, and some
whipping operations.
Speed 3 (High) — This is a fast speed for light work, such as whipping cream, beating eggs, and mixing
thin batters.
BOWL LIFT HANDLE
The BOWL LIFT HANDLE is used to raise and lower the bowl. To raise the bowl, rotate the Handle
downward; to lower the bowl, rotate the Handle upward.
MIXING
This section explains operation of the mixer and how to install bowls, agitators, and attachments. A
separate
Use and Applications Handbook
is provided with the mixer which contains information on mixing
procedures and outlines specific uses for agitators, attachments, and accessories.
Bowl
New mixer bowls and agitators (beaters, whips, and dough arms) should be thoroughly washed with hot
water and a mild soap solution, rinsed with either a mild soda or vinegar solution, and thoroughly rinsed
with clear water BEFORE being used. This cleaning procedure should also be followed for bowls and
agitators before whipping egg whites or whole eggs.
The bowl must be installed before the agitator.
To install the bowl, fully lower the bowl support. Position the bowl so the alignment bracket on the back
of the bowl is in the bowl retainer on the bowl support and the alignment pins on the front of the bowl support
fit in the holes in the bowl. Lock the bowl in place by rotating the bowl clamps over the ears of the bowl.
If a bowl adapter is required, install it on the bowl support as you would the bowl and then install the bowl
on the adapter.
Agitator
To install an agitator, the bowl must be installed and fully lowered. Place the agitator in the bowl, push
it up on the agitator shaft, and turn it clockwise to seat the shaft pin in the slot of the agitator shank.
To Raise the Bowl While Mixing
To raise the bowl while the agitator is mixing the product (when required by recipe or when using the Bowl
Scraper Attachment): Load ingredients. Close Wire Cage Assembly. Select Low speed. To begin mixing,
press and hold the Start button; then raise the bowl.