Filter
Top Products
– 13 –
OVEN DOOR
LAMP SHIELD RAIL
UPPER LAMP SHIELD
LIFT LAMP SHIELD
OVER RETAINING FEATURE
PULL LAMP SHIELD TOWARD YOU
LOWER LAMP SHIELD
(NON REMOVABLE)
PL-52646
REMOVING AND INSTALLING THE TOP LAMP SHIELD
Turn the oven off before removing the lamp shield.
The lamp shields MUST be kept clean to ensure maximum efficiency of the oven. If the lamp shields
are dirty, foods may not cook as quickly or as thoroughly as specified in the programmed recipes. The
lamp shields should be cleaned any time food or grease begins to build up on the shield surface.
Keeping the shields clean will prevent residue from baking on the shields and burning.
The upper lamp shield is easily removed with the door open. Lift the front edge of the lamp shield over
the retaining feature (Fig. 2) and pull it toward you.
To reinstall the lamp shield, place it on its rails and gently push it into the oven until it stops. Be sure
the lamp shield is properly seated behind the retaining feature.
Fig. 2
It is recommended that you obtain spare lamp shields so that dirty ones can be replaced quickly. Dirty
shields can then be cleaned during off-peak times.
The lamp shield is made of a special transparent material with specific properties. Replace
shield only with official
Flash
Bake oven replacements.