Filter
Top Products
– 6 –
START-UP TESTING
After the oven is connected to the supply circuit, perform the following tests to ensure that the oven
is operating properly.
Lamp Test
Turn the oven on by pressing the ON/OFF button. After a few
seconds, the display will settle on Recipe 1. At this point, hold down
the 1 button and push the 8 button at the same time. The display at
right appears:
Press the 1 button to begin the lamp test. The door will lock and the
lamps will each turn on briefly. After each of the four lamps are
turned on successfully, the display will report Lamp OK. When all
lamps pass, the oven will automatically return to the normal
operating mode.
If a lamp does not operate properly, the test will stop and the display
will show the number of the lamp that failed. The display at right is
an example:
Press any key to continue the test. At the end of the test, the display
will show “Lamp Check Finished.” If a lamp was reported as an
error, retest and verify visually that the lamp did or did not light.
If either of the two light sensors failed to operate during the test, you
will see the message at right at the end of the test:
If either a lamp or a sensor are reported as a problem, call your local
Hobart-authorized service office.
Voltage Test
After performing the lamp test, the display will return to Recipe 1.
On a new oven, the display will say Empty Recipe.
Press the green START button. The door will lock, the blower will
start, and a few seconds later the cycle will end and the door will
unlock. Now hold down the 1 button and push the 7 button at the
same time. The display reports the system voltage.
The voltage reported on this screen must match the nominal
system voltage supplied to the oven, either 208 Volts or 240 Volts.
Call your local Vulcan-authorized service office if it does not match.
Would You Like To
Check The Lamps
1 = Yes 2 = No
Lamp 2
Lamp Error
---->> Press Any Key <<----
Recipe 1 0:00
EMPTY RECIPE
208 Volts
Single Phase
Lamp Check Finished
No Bottom Sensor