Filter
Top Products
– 9 –
PROGRAMMING MEMORY KEYS
1
–
6
The oven must be set on Program Unlock to perform the functions on this page (refer to page 12).
Programming Memory Keys for Single Portions
1. Keep the door closed. Make sure the Display is blank. Program
Unlock must be active (not Program Lock).
2. While pressing the START key, press the POWER LEVEL key.
PROG will begin to blink in the Display.
3. Press the Memory key you wish to program
1
–
6
. For example,
if you press Memory key
2
, [ A2 ] displays with the other currently
programmed information for Memory key
2
.
4. Press POWER LEVEL to set the power level. The power level
displays. Example: [
HIGH ] or [ DEFROST ].
5. Turn the Timer Dial until the desired time appears in the Display.
Example: [ 14 00 ] indicates 14 minutes.
6. While pressing the START key, press the POWER LEVEL key.
[ PROG ] stops blinking. This means that you have finished
programming the selected Memory key.
7. Three seconds after programming is complete, the Display will
return to blank.
Programming Memory Keys for Two-Stage Cooking
Use the procedure outlined above for programming single stage
cooking and proceed through step 5. Then, repeat steps 4 and 5
before continuing with steps 6 and 7.
Programming the
X2
Pad for Multiple Portions
Small Portions The
X2
key is set at the factory to double the programmed time — this
is the correct setting for heating double portions of most small food
items such as sandwiches, bowls of soup or slices of pie. No further
programming is necessary. The maximum amount of time that can be
doubled on HIGH power is 15 minutes; on DEFROST, 30 minutes.
Larger Portions To heat multiple portions of large platters or bulk food loads, set
the time for slightly less than double the time required for a single
portion.
The HM1200 incorporates a
X2
Custom Program feature that allows
you to customize the heating time and/or power level for multiple
portions of your menu items.
For example: If Memory key 3 is set for 6:00 minutes on DEFROST, touching the
X2
key will display 12:00 minutes at DEFROST. If your own tests
have determined that the correct heating time for two portions is only
10 minutes and 30 seconds on DEFROST, the
X2
Custom Program
feature can be programmed for 10:30 at DEFROST.
PROG
STAGE HIGH
1
PROG
STAGE DEFROST
PROG
1
STAGE DEFROST
PROG
1
STAGE DEFROST
PROG
1