Filter
Top Products
© HOBART 2008 F25230 (Rev. A, May 2008)Page 1 of 8
LX/LXi, LXG/LXiG, AND SR24H DISHWASHERS
DWT2 DRAIN WATER TEMPERING KIT ML-130137
All kits must be installed by a Hobart Service Technician.
The Drain Water Tempering Kit reduces the temperature of drain water exiting an LX/LXi, LXG/LXiG, and SR24H
dishwashers by adding cold water to the drain water. The Drain Water Tempering Kit valve opens as the LX/LXi,
LXG/LXiG, and SR24H dishwasher drains and automatically adds cold water to the drain water.
NOTE: To make this a successful installation, the cold water line (45° F to 70° F [ 7° C to 21° C ] ) must be within
3' of the rear of the dishwasher. Recommended water service rough in is 1/2" trade size pipe (minimal) with shutoff
valve and 1/2" MPT connection.
Immediately after unpacking, check for possible shipping damage. If damage is found, save packing material and
contact the carrier within 15 days of delivery.
DWT-2 DRAIN WATER TEMPERING KIT (COMPLETE)
ML-130137-Z
Part No. Description Qty.
FP-22-12 Union, Pipe, 1/2" Straight 1
FP-40-42 Pipe, 1/2" x 1.125", Nipple 5
118038-2 1/2" Brass Regulator 1
918429 Gage, Pressure, Water 1
FP-27-07 Bushing, Pipe 1/2" to 1/4" 1
FP-019-21 Tee, Pipe 1/2" x 1/2" x 1/2" 1
270258 Strainer, Line, 1/2" Brass 1
435968-1 Valve, Solenoid, 1/2" 1
919862 Harness, DWT2, Cold Water Valve 1
223472 Backflow Preventer 1
918212 Fill Hose 1
FP-87-32 Hose, Fitting, 5/8" GHT x 3/4" MPT 1
FP-87-31 Hose, Fitting, 5/8" ID Barbed x 3/4" MPT 1
FP-90-89 Brass Wye, 3/4" x 3/4" x 3/4" 1
FP-41-50 Pipe, 3/4" x 1.375" 1
00-919275 Wiring Harness, LXI Pump Drain 1
00-919276 Wiring Harness, LX Sol Drain 1
00-814267 Harness, DWT, SR-24, Sol Drain 1
00-814290 Mounting Bracket Assy, SR24, DWT (SR24H Only) 1
919277 DWT2 Service Cover 1
FE-23-67 Strain Relief 1
FE-24-57 Connector Conduit 1/2" 2
543430 Electrical Conduit 6'
OF 044097-1 Wiring Diagram Solenoid Drain 1
OF 044097-2 Wiring Diagram Drain Pump 1
OF 033179 Diagram, Electrical DWT Kit (SR24H Only) 1
OF 025230 Instructions 1
113703 Wire Tie (SR24H Only) 2
SD-8-25 #10 Screw (SR24H Only) 1