Filter
Top Products
© HOBART 2008 F25230 (Rev. A, May 2008)Page 7 of 8
5. Connect the other two wires marked as Drain1
and Drain2 in harness 814267 to drain solenoid
valve as shown in Fig. 6.
6. Route the wire harness to the rear of the
machine along the left side wall.
7. Use a wire tie to bind the wiring harness to the
red float switch wires to ensure it is not lying on
the bottom of the dishwasher per Fig. 7.
8. Assemble the electrical conduit connector to the
strain relief bracket. Attach electrical conduit to
connector, run cold water valve wire harness
(919862) through conduit per Fig. 8.
9. Install the strain relief at other end of electrical
conduit per Fig. 9.
10. Use one of the knock outs on the valve cover to
install the electrical conduit connector. Run the
cold water valve wire harness (919862) through
the connector and install the electrical conduit to
the conduit connector per Fig.10.
11. Attach cold water valve wire harness to cold
water valve as shown in Fig. 10.