Filter
Top Products
– 11 –
MAINTENANCE
WARNING: TURN THE MACHINE OFF AND UNPLUG THE ELECTRICAL CORD BEFORE DOING
ANY MAINTENANCE.
Routinely inspect the machine to make sure that it is in proper working order. Plates must be clean,
intact and sharp.
The knife shaft should be regularly lubricated with a drop of mineral oil, NOT COOKING OIL.
REPLACEMENT DICING GRIDS
Depending on usage, dicing grids become dull from wear with an average life expectancy from 8 – 18
months. Dicing grids cannot be resharpened and are therefore expendable. Replacement dicing grids
are available from your local Hobart Service office.
TROUBLESHOOTING
SYMPTOM POSSIBLE CAUSE SUGGESTED ACTION
Machine will not start. A.
B.
C.
D.
E.
Feed cylinder not locked in correct
position.
Pusher plate or feed cylinder not
in proper operating position.
Pusher plate swung out beside
feed cylinder.
Fuse or circuit breaker interrupting
power.
Broken wire or connection.
Make sure feed cylinger is locked
correctly.
Fit pusher plate into proper operating
position.
Swing pusher plate into feed cylinder
center.
Check for blown fuses or fuses with
wrong amperage.
Pull electrical cord from receptacle
and call your local Hobart Service
Office.
Machine stops while operating
and won't restart.
A.
B.
C.
Pusher plate raised.
Fuse or circuit breaker interrupting
power.
Motor overloaded and thermal
motor protection has shut machine
off.
Swing pusher plate into feed cylinder
center and lower pusher plate.
Check for blown fuse or fuses with
wrong Amperage.
Thermal motor protection will
automatically allow motor to restart
when it has cooled.