Filter
Top Products
– 5 –
OPERATION
WARNING: ROTATING KNIVES INSIDE. ALWAYS USE PUSHER PLATE. KEEP HANDS OUT.
Proper assembly of the FP350, including selection of the appropriate cutters, is necessary for correct
operation of the food processor. Refer to the Cutting Tool Guide for sizes of cutters and refer to the
appropriate operation instructions.
CONTROLS (Fig. 1)
START (Green) — Push to start.
STOP (Red) — Push to stop.
Interlock switches prevent the food processor from operating when the feed cylinder is out of position
or the pusher plate is raised above the feed cylinder. If these features do not function as described,
contact your local Hobart Service Office.
During operation, when the pusher plate is fully raised above the feed cylinder, the food processor
stops and allows the pusher plate to be rotated clockwise for loading. To continue operation, rotate
the pusher plate counterclockwise until it is directly above the feed cylinder. As the pusher plate begins
to lower into the feed cylinder, the food processor will restart — you do not need to push the green
START switch unless STOP was pressed.
Always push the red STOP switch before changing cutters or cleaning.
FITTING AND REMOVING THE PUSHER PLATE
1. To fit the pusher plate, you MUST hold it with both hands in the exact positions shown in Fig. 2.
Hold it with the pusher plate handle to the left of the machine (as you face the front). Position the
pusher plate shaft against the bracket on the food processor.
2. Push the pusher plate down on the shaft with your right hand as far as it will go (Fig. 3). The pin
on the shaft of the pusher plate must slide into the slot in the bracket.
Fig. 2 Fig. 3