Filter
Top Products
– 11 –
Control Circuit Connection (All Models)
1. Remove the side service panel on the right side of the oven.
2. Route the single-phase supply wires through the knockout provided in the rear of the oven to the
control circuit terminal block. (See data plate for circuit amp requirements.)
3. Connect the line and neutral wire to the appropriately marked terminals.
4. Connect the ground wire to the green chassis ground screw located adjacent to the terminal block.
Heating Circuit Connection (Electric Ovens Only)
• Verify that the supply voltage to the oven, listed in the Heating Circuit Supply Voltage table,
matches the voltage listed on the data plate located behind the side service panel on the right
side of the oven.
• Route the supply wires through the knockout provided in the rear of the oven to the heating
circuit terminal block. (See data plate for circuit amp requirements.)
• Connect each wire to the appropriately marked terminals.