Hoshizaki DCM-270BAH-OS Ice Maker User Manual


 
15
9) Remove the louver and air lter. Plug the icemaker back in. Move the control switch to
the "DRAIN" position, then move the power switch to the "ON" position. Allow the water
system to drain completely (you will see the water draining into the drain pan).
10) Move the control switch to the "ICE" position. Allow the icemaker to ll with water
until the gear motor starts, then move the power switch to the "OFF" position. Move
the control switch to the "DRAIN" position, then move the power switch to the "ON"
position. Allow the water system to drain completely.
Note: To ensure that the drain valve opens immediately, you must move the power
switch to the "OFF" position before moving the control switch to the "DRAIN"
position. Otherwise, you may have to wait .5 minutes for the components to
cycle down before the drain valve opens.
11) Check the bin control for proper operation. To check, move the control switch to the
"ICE" position and allow the unit to run until the compressor comes on (compressor
comes on one minute after the gear motor starts). After the compressor comes on,
carefully lift the bin top off of the storage bin. WARNING! Keep hands, hair, and
loose clothing clear of the agitator rotating inside the storage bin. Lift and hold the
actuator on the bin top to activate the switch. The compressor should stop 90 seconds
later, and the gear motor should stop 60 seconds after the compressor.
1) Move the power switch to the "OFF" position, then unplug the unit. Replace all removed
parts and panels in their correct positions. On the push-button model, reconnect the
connector. WARNING! CHOKING HAZARD: Ensure all components, fasteners,
and thumbscrews are securely in place. Make sure that none have fallen into the
storage bin.
13) Plug the icemaker back in. Move the power switch to the "ON" position to start the
automatic icemaking process.