Filter
Top Products
18
1) Move the power switch to the "OFF" position, then remove the louver and air lter.
Move the control switch to the "DRAIN" position, then move the power switch to the
"ON" position. Allow the water system to drain completely.
13) Move the power switch to the "OFF" position, then unplug the icemaker.
14) Remove the front panel, top panel, and bin top.
15) Pour clean, warm water into the storage bin and melt any remaining ice. Remove the
agitator and drip ring. Rinse the inside of the storage bin, the agitator, and drip ring
thoroughly with clean water.
16) Pour clean, warm water over the extruding head until the evaporator assembly and the
reservoir are full and the water starts to overow into the drain pan. Plug the icemaker
back in, then move the power switch to the "ON" position. Allow the water system to
drain completely.
Note: If you do not sanitize the unit, move the power switch to the "OFF" position
after the water system drains. Unplug the icemaker, then replace the drip ring,
grille, spout A, and spout B in their correct positions. Go to step 10 in "III..C.5
Sanitizing Procedure - Final."
17) Move the power switch to the "OFF" position, then unplug the icemaker.
3. Sanitizing Solution
IMPORTANT
For safety and maximum effectiveness, use the solution immediately after
dilution.
Dilute 1.5 . oz. (44 ml or 3 tbs) of a 5.5% sodium hypochlorite solution (chlorine
bleach) with 3 gal. (11.4 l) of warm water. This is a minimum amount. Make more
solution if necessary.
4. Sanitizing Procedure - Initial
1) Make sure the power switch is in the "OFF" position, the icemaker is unplugged, and
the water supply line shut-off valve is closed.
) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to overow into the drain pan. Allow the
icemaker to soak for about 10 minutes before operation.
3) Scrub the inside of the storage bin, inside of the bin top, the agitator, drip ring, ice chute
area, spout A, spout B, grille, and the inside of the drain pan using a nylon scouring
pad, brushes, and sanitizing solution. Rinse all parts thoroughly with clean water.
CAUTION: Be sure to keep the switch mounted on the bin top dry.
4) Make sure you have allowed the icemaker to soak for about 10 minutes
5) Move the control switch to the "ICE" position. Replace the air lter, louver, drip ring,
agitator, bin top, grille, spout A, spout B, and panels in their correct positions.
6) Plug the icemaker back in. Move the power switch to the "ON" position. Make ice using
the solution until the icemaker stops making ice.
7) Move the power switch to the "OFF" position, then unplug the icemaker.