Filter
Top Products
23
9. START UP - See Fig. 99. START UP - See Fig. 9
9. START UP - See Fig. 99. START UP - See Fig. 9
9. START UP - See Fig. 9
WARNINGWARNING
WARNINGWARNING
WARNING
1. All parts are factory-adjusted. Improper adjustments may result in failure.
2. If the unit is turned off, wait for at least 3 minutes before restarting the ice
dispenser to prevent damage to the Compressor.
1) Clean the Storage Bin.
2) Open the Water Supply Line Shut-off Valve.
3) Turn on the power supply.
4) Remove the Front Panel.
5) Turn on the Power Switch on the Control Box.
This ice dispenser is provided with a Door Switch and will not operate without the
Front Panel.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Be sure that the Control Switch, located at the bottom of the Middle Front
Panel, is moved to the “ICE” position.
6) Replace the Front Panel in its correct position.
7) Check that water flows into the Water Supply and Freezer Assembly.
• Water flows into the Reservoir through the Water Valve.
• Water flows into the Freezer bottom through the Feeder Tubing.
• The Float Switch trips to shut off or close the Water Valve.
8) Check the water supply and drain connections for water leaks.
9) After the Water Valve closes, the Gear Motor starts first, then the Compressor, and
an automatic and continuous icemaking process starts.
10) In a few minutes, cubeIet ice is extruded into the Storage Bin.