Filter
Top Products
26
11. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig. 1111. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig. 11
11. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig. 1111. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig. 11
11. PREPARING THE ICEMAKER FOR LONG STORAGE - See Fig. 11
and 12and 12
and 12and 12
and 12
WARNINGWARNING
WARNINGWARNING
WARNING
When shutting off the ice dispenser for an extended time, drain out all water
from the water line and remove the ice from the Storage Bin. The Storage
Bin should be cleaned and dried. Drain the ice dispenser to prevent dam-
age to the water supply line at sub-freezing temperatures, using air or
carbon dioxide gas. Shut off the ice dispenser until the proper
ambient temperature is resumed.
1) Close the Water Supply Line Shut-off Valve.
2) Move the Dispense Mode Switch, on the bottom of the Middle Front Panel, to the
“CONTINUOUS” position.
3) Press the Push Button to dispense ice, and remove all ice from the Storage Bin.
4) Move the Control Switch, on the bottom of the Middle Front Panel, to the “Drain” position
and wait for about 15 minutes for the water system to drain.
5) Remove the Upper Front Panel.
6) Turn off the Power Switch.
7) Replace the Upper Front Panel and move the Control Switch back to the “ICE” position.
Fig. 11Fig. 11
Fig. 11Fig. 11
Fig. 11