Filter
Top Products
29
8) Wait for 10 minutes before starting the icemaking process. Then turn on the Power
Switch and move the Control Switch to the “ICE” position. Run the ice dispenser until it
stops automatically.
Note: This ice dispenser will not run without the Front Panel.
Replace the Top Panel and the Front Panel.
9) Repeat Step 5).
10) Pour water into the Reservoir to rinse the cleaning solution, and drain the water system.
See 5).
11) Dilute approximately 0.82 fl. oz. of a 5.25% Sodium Hypochlorite Solution with 1.6
gal. of water.
12) Pour the sanitizing solution into the Reservoir. Be careful not to overfill.
13) Wait for 10 minutes before starting the icemaking process. Turn on the Power
Switch and move the Control Switch to the “ICE” position. Run the ice dispenser until it
stops automatically.
14) Repeat Step 5).
15) Rinse out the sanitizing solution. See 10).
16) Replace the Water Valve, the Top Panel and the Front Panel.
Note: Be sure to replace the Water Valve Packing.
17) Open the Water Supply Line Shut-off Valve, turn on the Power Switch, and run the
ice dispenser for about 30 minutes.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Do not use ice produced from the cleaning and sanitizing solution. Be
sure none remains in the Storage Bin.