Filter
Top Products
28
5) Replace the front panel in its correct position.
6) Remove all ice from the dispenser unit/storage bin. Clean the dispenser unit/storage
bin using a neutral cleaner. Rinse thoroughly after cleaning.
7) Close the icemaker water supply line drain valve.
3. On water-cooled model only, remove the water from the water-cooled condenser:
1) Turn off the power supply and remove the front panel.
2) Move the control switch on the control box to the “OFF” position.
3) Remove the top panel and right side panel.
4) Close the condenser water supply line shut-off valve. If connected to a closed loop
system, also close the condenser return line shut-off valve. See Fig. 10 or 11.
5) Open the condenser water supply line drain valve. If connected to a closed loop
system, also open the condenser return line drain valve.
6) Attach a compressed air or carbon dioxide supply to the condenser water supply line
drain valve.
7) Open the water regulating valve by using a screwdriver to pry up on the spring retainer
underneath the spring. While holding the valve open, blow out the condenser using the
compressed air or carbon dioxide supply until water stops coming out.
Note: Be sure to close the water regulating valve as before.
8) Close the condenser water supply line drain valve. If connected to a closed loop
system, also close the condenser return line drain valve.
9) Replace the top, right side, and front panels in their correct positions.
IV. Disposal
The appliance contains refrigerant and must be disposed of in accordance with applicable
national, state, and local codes and regulations. Refrigerant must be recovered by properly
certifi ed service personnel.
IMPORTANT
The insulation foaming agent used for the unit body contains fl ammable gas
cyclopentane. With this in mind, dispose of the product properly.