Filter
Top Products
You may need to remove both doors for the
appliance to fit through access doors -
follow the instructions below:
Feed Water Tube:
* Remove the lower cover by lifting upwards.
* Pull out the feed water tube,while pressing
area (1) indicated in Fig.1
Remove the Freezer Compartment Door:
* Loosen the screws in the upper hinge
cover and remove. Separate all connection
wires,except for the earth line (Fig.2).
* Remove the retainer by rotating it anti-
clockwise (a - Fig.3),then remove the
upper hinge by lifting up.
* Remove the freezer compartment door by
lifting it up off the lower hinge.
Lift enough so that the feed water tube is
completely pulled out (Fig.4)
Installation
WARNING:ENSURE THE APPLIANCE IS NOT
CONNECTED TO THE ELECTRICITY SUPPLY
BEFORE INSTALLING.
WARNING:YOU MAY NEED ASSISTANCE TO
DO THIS - THE DOORS ARE HEAVY AND
SHOULD BE SUPPORTED AT ALL TIMES TO
AVOID DAMAGE AND INJURY.
NOTE: Cut away any tube end which is
misshapen or worn
NOTE: Support the door when removing
the upper hinge.
NOTE: Carry the freezer compartment
door through the access door and lay it
down on suitable material eg.the original
packaging.
Take care not to bend or damage the feed
water tube.
6
Fig.1
Fig.2
Fig.3
Fig.4