Filter
Top Products
Installation
9
●
FINALLY: Plug in and switch on the electricity supply. Turn on the water supply tap.
Check for any leaks. Ensure selection is set to ‘water’(see page 15) push a cup under
the dispenser to verify that water is flowing. When all working OK,move the appliance
into its final location - your appliance is heavy and care should be taken when moving
it,also do not trap or kink hoses at the back of the appliance. Replace the lower cover.
Mount the water filter in an accessible position using the self-adhesive fixing plates
and cable ties supplied.
●
Connection of Water Filter:
●
Connection to the Water Tap:
* Unscrew the threaded connector and
place it over the end of the cut
section of pipe coming away from
the appliance. Push the pipe over the
end of the water filter that the arrow
points to and tighten the threaded
connector (Fig.D)
* Cut the pipe that is connected to the water filter to the
correct length. Again,make sure that the cut is nice and
square to avoid leaks.
* Push the pipe into the smaller hole of the connector
supplied in the adaptor kit. The pipe should be held
firm (Fig.F)
* Place the threaded tap connector over the long part of
the brass flange. Firmly push the flange into the other
end of the water connector (Fig.G)
* Place the rubber washer inside the threaded tap
connector and screw onto the water tap.
* Repeat on the other end of the water
filter,using the remainder of water
pipe (Fig.E)
* Run this section of water pipe from
the water filter to the water supply
tap,making sure it is not trapped or
kinked at all.
Note the direction markings on the filter
* Now you have to cut the pipe to the length it needs to be to run from the back of the
appliance and attach to the water filter.
NOTE: The water filter is marked with an arrow to show the direction of water flow (ie.from
supply tap to appliance).
Remember however,that the connection process is being done FROM the appliance TO the
tap (ie.in reverse of the water flow when in use).