Filter
Top Products
●
FIRST CHECK YOU HAVE THE CORRECT
ITEMS:
- Pipe / Filter Kit comprises:
* 1 x Water Filter
* 2 x Self-Adhesive Fixing Plates
* 2 x Cable Ties
* 1 x 10m Water Pipe
- Adaptor Kit comprises:
* Plastic Pipe Connector
* Rubber Washer
* Threaded Tap Connector
●
NEXT,HAVE A LOOK AT THE DIAGRAM
BELOW TO VISUALISE HOW THE
APPLIANCE SHOULD BE CONNECTED:
Installation
8
Fridge
Filter
Water Pipe
Water Pipe
Tap
●
Connection to the Appliance:
* At the back of the
appliance you will see
the water inlet valve
(Fig.A)
* You now need to cut the water pipe to the right length for the
connection of the water filter.
It is suggested that approximately 1.5m of pipe is used - this
should allow the filter to be located in an easily accessible
position (as the water filter should be replaced approximately
every 6 months,according to use and conditions) and also allow
some slack in the pipe behind the appliance,so that it can be
pulled out for cleaning or servicing purposes.
You must also ensure that the cut is square and not at any
sort of angle as this could cause a leak.
* Unscrew the metal
threaded collar and
place it over one end of
the water pipe (Fig.B)
* Push the water pipe
onto the water inlet
valve firmly,tighten up
the metal collar (Fig.C)
✓
✗