Filter
Top Products
Millennium II 6000 Installation Manual
Publication Number: 620919546INS - 8 - © 2003-2004, IMI Cornelius Inc.
NOTE: It will be necessary to melt the ice bank to be able to pull the refrigeration deck up and
away from the dispenser. Warm water may be used to accelerate the melting. In order to prevent
ice bank control damage, do not direct the warm water stream on to the sensing probe of the ice
bank control. Never use an ice pick or other instrument to remove ice from the evaporator. Such
practice can result in a punctured refrigerant circuit or damage to the water bath tank.
F. Once the ice bath is sufficiently melted, remove the two hitch pins securing the refrigeration deck
to the water bath tank and lift the deck using the two handles.
G. Prepare 1 gallon (3.8 l) of cleaning and sanitizing solution (see “Sanitizing the Concentrate Lines
& Valves”). Pour the cleaning and sanitizing solution into the water bath and clean the sides and
bottom of the tank, the product coils and associated brackets with a fiber brush.
H. Using the solution in the water bath, the fiber brush and a clean cloth soaked with solution, clean
the refrigeration deck’s evaporator coils, agitator motor shaft and blade, and the ice bank sensing
probe.
I. Drain the cleaning and sanitizing solution from the water bath and rinse/flush all the components
with clean water.
J. Reinstall the refrigeration deck into the water bath and secure the hitch pins.
K. Plug the connectors into their appropriate receptacles on the electrical box.
L. Fill the water bath with cool potable until water begins to trickle from the overflow tube.
M. Install the top, side and rear panels, as well as the merchandiser. Connect the harnesses from
the merchandiser and top panel to their appropriate terminals.
N. Plug the dispenser into the electrical outlet and turn the unit on.