Filter
Top Products
UF-1 and UFB-1 Valves Training Manual
- 10 - © 1999-2005, IMI Cornelius Inc.
5. Remove valve from mounting
block by pushing locking tab to left
and push down on top plate of
block. .
6. Remove water screw and lever (if it is installed
on the valve).
7. Remove nozzle – turn left ¼ turn.
8. Remove diffuser assembly.
Note: The diffuser must be cleaned daily. Do not use bleach,
do not use detergent, do not put in dishwasher. Use lukewarm
water or soak in carbonated water.
9. Remove bottom plate by disengaging side tabs.
10. Remove U-shaped retainer wire from back of valve.
11. Grasp flow control module assembly and pull
up.
Note: O-rings on bottom of inlets and outlets.
Locking tab
Locking tab
Mounting
screw
Water
lever
Tabs
Retainer
wire
O-rings
SYSTEM DETAILS