Filter
Top Products
UF-1 and UFB-1 Valves Training Manual
- 12 - © 1999-2005, IMI Cornelius Inc.
4.2 Mounting Block Disassembly
To disassemble mounting block:
16. Then remove 5 screws that secure the
valve head to the valve body.
17. To remove the dispensing lever return spring pry the
end of the spring and pull up. This spring stops the
lever from vibrating.
1. Turn off water and syrup supplies.
2. Remove 2 screws from top plate and pull spools
out from the bottom of the mounting plate exposing
spools and O-rings.
Note: When replacing mounting block use replace-
ment O-rings for the inlet fittings.
3. When installing a new block, make sure
it is locked in the open position..
Pry here
O-rings
Block closed (up)
Block open (down & locked)
SYSTEM DETAILS