Filter
Top Products
LCX9000 Liquid-Cooled Drives User Manual
MN04005001E
For more information visit: www.EatonElectrical.com 2-1
January 2007
Chapter 2 — Installation
Mounting
Liquid-cooled drive modules must be installed into an enclosure. The drives consisting of
one module will be mounted on the mounting plate. The drives that include two or three
modules are mounted inside a mounting bracket, which will then be installed in the
enclosure.
Note: If any other than vertical installation position is required, please contact your
distributor!
On Page 2-2 you will find the dimensions of liquid-cooled drives installed on mounting bases
(plates and brackets).
Lifting the Drive
Eaton recommends use of a jib crane or similar elevating device to lift the drive unit. See
Figure 2-1 for correct lifting points.
Use either the hole(s) in the middle of the mounting plate (Lifting point 1) or the hole in the
H-shaped part of the mounting plate (Lifting point 2) for lifting the drive. See Figure 2-1.
Figure 2-1: Lifting Points for Drives Consisting of One Module (Left) and Several Modules
Approximate Dimensions in Inches (mm)
Lifting Point 1
.51 (13.0) Dia.
Lifting Point 1
.51 (13.0) Dia.
Lifting Point 2
.35 (9.0) Dia.