Jenn-Air ELECTRIC DOWNDRAFT SLIDE-IN RANGE Range User Manual


 
6
Notes:
If the oven door is left open, CLOSE DOOR will appear in
the display until the door is closed.
If more than 30 seconds elapse between pressing the
Clean pad and pressing a number pad, the program will
automatically return to the previous display.
The oven door will be damaged if it is forced to open
during cleaning or cooling process.
The first few times the oven is cleaned, some smoke and
odor may be detected. This is normal and will lessen or
disappear with use. If the oven is heavily soiled, or if the
broiler pan was accidently left in the oven, excessive
smoke and odor may occur.
As the oven heats and cools, you may hear sounds of
metal parts expanding and contracting. This is normal
and will not damage your appliance.
After Self-Cleaning
About one hour after the end of the clean cycle, the lock
will disengage and OVEN COOLING will go off in the
display. At this point, the door can be opened.
Some soil may leave a light gray, powdery ash which can be
removed with a damp cloth. If soil remains, it indicates that
the clean cycle was not long enough. The soil will be removed
during the next clean cycle.
If the oven racks were left in the oven and do not slide
smoothly after a clean cycle, wipe racks and embossed rack
supports with a small amount of vegetable oil to restore ease
of movement.
A white discoloration may appear after cleaning if acidic or
sugary foods were not wiped up before the clean cycle. This is
normal and will NOT affect performance.
Cont.
PART PROCEDURE
CAUTION
Cleaning Procedures
Be sure appliance is off and all parts are cool before handling
or cleaning. This is to avoid damage and possible burns.
To prevent staining or discoloration, clean appliance after each use.
If a part is removed, be sure it is correctly replaced.
Access Panel The access panel is easily removed. To open panel, grasp sides and pull upward, lifting out.
To close panel, align catches with the studs on the range. Press the access panel
forward onto the studs and drop downward to engage.
Wash with soap and water, a glass cleaner, or mild liquid sprays.
Do not use excessive amounts of water.
To prevent scratching or dulling of the finish, do not use mildly abrasive, harsh or
caustic cleaners such as oven cleaners.
Important: To avoid the possibility of accidentally disconnecting any part of the
ventilation system, do not use the area behind the access panel for storage.
Control Panel To activate control lock for cleaning, see Locking the Control, page 18.
Wipe with damp cloth. Dry thoroughly.
Glass cleaners may be used if sprayed on a cloth first. DO NOT spray directly on control pads and
display area.
Do not use other cleaning sprays, abrasive cleaners or large amounts of water on the panel.
Control Knobs Remove knobs in the OFF position by pulling forward.
Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.
Turn on each element to be sure the knobs have been correctly replaced.
* Brand names are registered trademarks of the
respective manufacturers.
** To order call 1-800-JENNAIR (1-800-536-6247).
GREASE
CUP
STUDS
CATCHES
8113P630-60 5/3/06, 8:59 AM7