Filter
Top Products
9 Surface Cooking
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Surface Indicator Lights
This light is on when the corresponding surface _ To lift cooktop: When cool, grasp the front edge of the
element is on. The light will turn off when the _ cooktop. Gently lift up until the two support rods at the frontsurface element is turned off. of the cooktop snap into place.
Hot Surface Lights U I
(glass-ceramic cooking surface models only)
[
Each element has a hot surface _ ' L[ _ SUPPORTROD
indicator light. A light will be ___,.___
V
illuminated when the / -"_,,,_"_
matching surface / uG_°rro_cng_op"_'_
element is hot. II _ /" ///_v
will remain on, even _ S/ To lower cooktop: Hold the front edge of the cooktop and
after the control is turned off, _ _ carefully push back on each support rod to release. Then
until the area has cooled. They are _ gently lower the top into place. The support rods will slide
located at the front center of the cooktop, into the range frame.
Panel Light Coil Elements
The panel light is turned on by pushing the • When an element is turned on, it will cycle on and off
rocker switch on the backguard and hold- to maintain the heat setting.
ing it until the light comes on. It may be • Coil elements are self-cleaning.
turned off by pushing the other side of the Panel
switch. • Do not immerse in water.
To remove: When cool, raise element. Carefully pull out
Coil Element Surface and away from receptacle.
(select models)
Lift-up Porcelain Cooktop
To prevent the cooktop from discoloring or staining:
• Clean cooktop after each use.
• Wipe acid or sugar spills as soon as the cooktop has To replace: Insert terminals on the element into receptacle.
cooled as these spills may discolor or etch the
Guide the element into place. Gently press down on the outer
porcelain, edge of the element until it sits level on the drip bowl.
Your range features an upswept porcelain cooktop that can be
lifted up for convenient access to the area under the cooktop.
TERMINALS