Filter
Top Products
If youare installingyournew refrigeratoryourself,please followthese helpfulsugges-
tions.
1. Remove base skids. IlllJll I
2. Remove all exterior and interior tape carefully and
retain old tape. Makea small pad of this tape to pick
offanyremainingtaperesidues. Thiswill eliminatethe
need to use dangeroussolvents of any kind.
3, Removeanddiscardthe cantilevershelf packing clips
located just above each shelf where they hook onto
the frame. TO remove the red plastic clip, wiggle it
sidewaysand pull straight out.
4. Selecta locationfor yournew refrigeratoraway from anyheat sources. Allow afree
flow of airthrough the front base gdfle.
5. Your model should notbe installed where the room temperature willgo below
55oF. because itwillnot runfrequently enough to maintain propertemperature in
the freezer.
To enhance its appearance, maintainefficient performanceand for properfunctionof
the ice maker, your refdgerator should be level Using a carpenter's level, check your
refrigerator to make sureit is levelfront to back andsideto side. Thefront wheels were
adjusted at the factory so the cabinet would be level. However, jarring in transit, or
standingtherefrigerator onanunevenfloormay causethedoorstoshiftoutofalignment.
If levelingis necessary, remove the base grilleand adjust thewheel with a screwdriver
as shown.
TOlock the cabinet inplace, turn down one or both LOWER¢,o,,ErCO..E_
locking feet, located near the front wheels. Rear
levelerfeet are notrequired.
7_JRNCOUNTERCLCCKW_
31_RAISECABINEtCORNER
[] TO CORRECTTHIS COND[- []
TION, RAISE RIGHT COR- TO CORRECT TN(S CONO(T(ON, RAISE
HER AND fOR LOWER LEFT LEFT CORNER AND/OR LOWER RIGHT
I CORNER UNTIL OOORS CORNERUNTfLDQORSALIGNACROSS
'ALIGN ACROSS TOP OF TOP OFCABINET.
CABINET.
4