Filter
Top Products
exit the program. In this case the S9 OT will remind you with the
message CLEAN MACHINE.
2. Make sure that the water container is at least half full.
3. Push the Rinse Button.
EMPTY TRAY.
4. Remove and empty the tray and the used coffee container
and replace.
Attention: If the tray and the used coffee container are
already empty, you still need to remove the tray for approx.
20 seconds and then replace it.
PRESS RINSE.
5. Place containers (20 oz.) under the coffee spout and the
frothXpress (Fig. 4) and push the Rinse button (Fig. 2.E).
The display shows
CLEANS. After a short while you will hear
a beep and the display shows ADD TABLET/PRESS RINSE.
6. Open the ground coffee funnel lid and drop one white tablet
into the opening (Fig. 22). Close lid.
7. Push the Rinse button. The display shows
CLEANS. The
machine will start the automatic cleaning program by
dispensing water in intervals into the containers underneath
the spouts. When finished, the display shows
EMPTY TRAY.
8. Remove the tray. There will be water in the tray and in the
used coffee container. Empty, clean and replace. The display
shows
COFFEE READY.
9. Clean the ground coffee funnel. Remove the funnel and rinse
under hot water and dry Replace funnel (Fig. 20 and 21).
16.2 MANUAL TABLET CLEANING
This program is useful if the brewing process slows down due to
excessive oil build-up inside the machine.
COFFEE READY.
• Push and hold the Rotary Dial. MAINTENANCE.
• Push the Rotary Dial, display shows
CLEAN CAPPUCCINO.
• Turn the dial until the display shows
CLEAN MACHINE
and push the dial. The display shows DURATION 20 MIN. /
START YES.
• Continue with the steps 2 through 9 from the chapter 16.1.
17. DECALCIFYING
The machine has an integrated decalcifying program. This
program takes 45 minutes. When the display shows
COFFEE
READY / DECALCIFY MACHINE it is time to decalcify the
machine. The Rinse button is illuminated. You can still make
coffee. However, it is highly recommended to decalcify the
machine within the next 3 to 4 days.
Please note: If you use the Clearyl water cartridge and the
display shows DECALCIFY MACHINE then your cartridge
function is not activated. Follow the instructions in chapter 13a
to activate the Clearyl Cartridge. If the cartridge is in use for
several weeks install a new cartridge.
Important: The decalcifying program must not be interrupted.
NOTE: Only use our special, square decalcifying tablets
Model # 66281, see chapter 20.
CAUTION: Never use vinegar or any other decalcifying agent.
This might damage internal parts of the machine.
CAUTION: Immediately remove any splashes of the decalcifying
solution from sensitive surfaces, such as natural stone or wood.
CAUTION: If the decalcifying solution comes in contact with the
skin, rinse it off with water. If the solution comes in contact with
your eyes, see a doctor.
Important: Always wait until the decalcifying solution in the
water tank has been used up. Do not fill additional decalcifying
solution into the water tank.
33.