Filter
Top Products
20
15. Programming
The IMPRESSA leaves the factory with a number of default
settings that allow you to make coffee without having to pro-
gram the machine first. You can, however, adjust various
parameters to make the coffee suit your personal taste.
The following parameters can be programmed:
ț Filter
ț Water hardness
ț Maintenance
ț Temperature
ț Coffee strength
ț Cappuccino
ț Milk
ț Save energy
ț Time
ț Automatic switch-on time
ț Automatic switch-off time
ț Information
ț Rename
ț Language
ț Display
15.1 Programming the filter
Please refer to Chapter 5 “Using the CLARIS plus filter cartridge”.
15.2 Programming your machine to the correct
water hardness (only with FILTER NO)
Please refer to Chapter 4 “Adjusting your machine to the water
hardness”.
15.3 Maintenance
You can activate the following maintenance functions from this
program item:
RINSING MACHINE, CLEAN CAPPUCCINO,
CHANGE FILTER, CLEAN UNIT, RINSE CAPPUCCINO,
DECALCIFY MACHINE.
“DECALCIFY MACHINE” is not displayed if you are using a
CLARIS plus filter and the filter is set to “Yes”.
“CHANGE FILTER” is not displayed if you are not using a
CLARIS plus filter and the filter is set to “No”.
Ⅲ COFFEE READY
Ⅲ
Ⅲ Press the Rotary Switch (B) until you hear an acoustic signal.
Ⅲ FILTER
Ⅲ NO or YES
Ⅲ Turn the Rotary Switch (B) until the following message is dis-
played:
Ⅲ MAINTENANCE
Ⅲ
Ⅲ Press the Rotary Switch (B) to start programming.
Ⅲ RINSE UNIT
Ⅲ
Ⅲ Turn the Rotary Switch (B) until the required maintenance func-
tion (for selection see above) is displayed. Press the Rotary
Switch (B) to activate the function.
15.4 Programming the temperature for coffee,
espresso, cappuccino and special coffee
You can adjust the temperature for each type of coffee sepa-
rately. The temperature can be set to 3 different levels
(LOW, NORMAL, HIGH).