Filter
Top Products
17
15. Programming
When your IMPRESSA leaves the factory it is adjusted such
that you can draw off coffee without having to change any
settings. However, you can programme various parameters
individually.
You can programme the following stages:
¼ Filter
¼ Water hardness
¼ Maintenance
¼ Aroma
¼ Temperature
¼ Time
¼ Automatic switch-on time
¼ Automatic switch-off time
¼ Draw-offs
¼ Language
¼ Display
¼ Exit
To start programming, press the Rotary Switch (1) until
FILTER –/ߛ appears
Rotary switch
Turn the Rotary Switch to change the adjusted values or to
select the next programming step.
Press the Rotary Switch to check the values adjusted or to
save the values selected (Fig. 17).
15.1 Programming the filter
Refer to Chapter 5.1 «Inserting the filter».
15.2 Programming the water hardness
Refer to Chapter 4 «Adjusting the water hardness».
15.3 Maintenance menu
Ⅲ READY
Ⅲ Press the Rotary Switch (1) until
FILTER –/ߛ appears
Ⅲ The illuminated ring (2) is active.
Ⅲ Turn the Rotary Switch (1) until
MAINTENANCE appears
Ⅲ Press the Rotary Switch (1)
Ⅲ RINSE
Ⅲ Turn the Rotary Switch (1) until the required program item ap-
pears on the display (9).
Ⅲ e.g. RINSE, CLEAN, FILTER, DE-SCALE or EXIT
Ⅲ e.g. CLEAN
Ⅲ Press the Rotary Switch (1)
Ⅲ The cleaning program starts.
Ⅲ EMPTY TRAY
Ⅲ Continue with Chapter 17 Cleaning, from point 3
EMPTY TRAY
15.4 Programming the aroma INTENSIVE
or STANDARD
When the machine leaves the factory, the aroma is set to
intensive. If requested it can also be set to Standard.
Ⅲ READY
Ⅲ Press the Rotary Switch (1) until
FILTER –/ߛ appears
Ⅲ The illuminated ring (2) is active.
Ⅲ Turn the Rotary Switch (1) until Aroma is displayed.
Ⅲ AROMA
E