Filter
Top Products
7
USING THE PROCESSING
BLADE/DISCS
All blades must be handled carefully
as they are sharp!
Using the processing/mixing blade
a. Select either the processing or plastic
mixing blade
b. Place the processing /mixing blade over
the drive shaft and push down.
Using the slicing/grating discs.
a. Select the desired slicing/grating disc and
assemble into the disc holder.To fit the
stainless steel disc onto disc holder, fit
left side of disc (when writing is towards
you), with locating tab into holder, then
push right side down firmly until it locks
into place. Fit the end without the push
up marking in first.Then push the “push
up” side down firmly until it locks into
place.
b.To remove disc, hold disk away and
place thumbs underneath disc at top
of disc marked “push up” and push
out.The disc may be tight for the first
few times.
Correct placement of the
processor lid
Place the lid on top of the bo
wl,
align the
indicator line on the lid with the cir
cle
on the bo
wl.
Locate tab
Push down