Filter
Top Products
10
13. Place one hand on top of the
Mixer Head and with the other
hand press and hold the ‘Tilt’
button to lift the Mixer Head up
until it stops. Release the ‘Tilt’
button. The Mixer Head is now in
the elevated position.
14. Remove the leaf beater, dough
hook or whisk attachment as
described prior in the Removing
the Leaf Beater/ Dough Hook/
Whisk Attachment section on
page 8. Use a spatula to remove
the mixture from the leaf beater,
dough hook or whisk attachment.
Do not strike the leaf beater,
dough hook or whisk attachment
on the rim of the mixing bowl.
WARNING: After mixing,
take out the leaf beater,
dough hook or whisk
attachment with care as
they may be hot after use.
Overload Protection System
The motor is protected from burning
out by a manual reset cut-out switch.
If the Bench Mixer is overloaded or
operated continuously for too long,
the motor may overheat and stop. To
operate the Bench Mixer again, you
must switch off, unplug and allow to
cool for approximately 30 minutes.
Once the motor has fully cooled,
it is ready for use again. Some stiff
mixtures, such as dough, may cause
the dough hook to rotate more slowly
than normal.
Do not operate the Bench Mixer
continuously with an excessive load
for more than 3 minutes. If this occurs
again, the mixing bowl may be
overloaded, so remove some of the
food and process in smaller batches.