Filter
Top Products
5
Important Safeguards For All Electrical Appliances
• Always remove the attachment from the
Bench Mixer before cleaning. Care should
be taken when removing the food from
the mixing bowl by ensuring the motor and
the attachment have completely stopped
before disassembling. Ensure the Speed
Control Dial is in the ‘OFF’ position, the Bench
Mixer is switched off at the power outlet and
unplugged before unlocking the Bench Mixer
head and moving into the upright position.
The attachment should be released from the
Mixer Head before attempted to remove the
processed food from the mixer bowl and
the attachment.
• Ensure the Bench Mixer head is locked into the
horizontal (closed) position when not in use
and before storing.
• Always ensure the Speed Control Dial is in
the ‘OFF’ position, the power is switched off
at the power outlet before attempting to
move the Bench Mixer, before assembling
or disassembling the Bench Mixer, when the
Bench Mixer is not in use and before cleaning
or storing.
• Do not move the Bench Mixer whilst
in operation.
• Always switch off the Bench Mixer and
disconnect from the power outlet before
removing attachments, changing accessories
or approaching parts that move in use.
• Fully unwind the power cord before use.
• Connect only to a 230V or 240V power outlet.
• Do not let the power cord hang over the
edge of a bench or table, touch hot
surfaces or become knotted.
• To protect against electric shock, do not
immerse the power cord, power plug or
appliance in water or any other liquid or
allow moisture to come in contact with
the part, unless it is recommended in the
cleaning instructions.
• The appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental abilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
• It is recommended to regularly inspect the
appliance. To avoid a hazard, do not use
the appliance if power cord, power plug or
appliance becomes damaged in any way.
Return the entire appliance to the nearest
authorised Kambrook Service Centre for
examination and/or repair.
• Any maintenance other than cleaning
should be performed at an authorised
Kambrook Service Centre.
• This appliance is for household use only. Do
not use this appliance for anything other than
its intended use. Do not use in moving vehicles
or boats. Do not use outdoors. Misuse may
cause injury.
• The installation of a residual current device
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances. It is advisable that a
safety switch with a rated residual operating
current not exceeding 30mA be installed in
the electrical circuit supplying the appliance.
See your electrician for professional advice.
• Always turn the appliance to the OFF position,
switch off at the power outlet and unplug at
the power outlet when the appliance is not
in use.
• Before cleaning, always turn the appliance
to the OFF position, switch off at the power
outlet, unplug at the power outlet and
remove the power cord, if detachable, from
the appliance and allow all parts to cool.
• Do not place this appliance on or near a heat
source, such as hot plate, oven or heaters.
• Position the appliance at a minimum distance
of 20cm away from walls, curtains and other
heat or steam sensitive materials and provide
adequate space above and on all sides for
air circulation.
• Do not cover the air vents on the Mixer Head
and Mixer Stand to avoid overheating.
• The use of any accessory attachments not
recommended by Kambrook may
cause injuries.
• Do not leave the Bench Mixer unattended
when in use.
• Do not place any part of the Bench Mixer
except the mixing bowl in the dishwasher.
• Keep the Bench Mixer clean. Follow the Care,
Cleaning and Storage instructions provided in
this book.
CAUTION: In order to avoid
a hazard due to inadvertent
resetting of the thermal
cut-out, this appliance must
not be supplied through
an external switching
device, such as a timer, or
connected to a circuit that
is regulary switched on and
off by the utility.